Electrical Trades Forms

UEE30820 Certificate III in Electrotechnology Electrician is the underpinning trade qualification for licensed...

Apprentices and trainees pursuing UEE30820 Cert III Electrotechnology Electrician (id 1248) must hold an Apprentice /...

A Certificate of Electrical Safety (COES) is the Victorian compliance certificate required for all prescribed and most...

A Certificate of Compliance for Electrical Work (CCEW) is the NSW compliance certificate required for any electrical...

In Queensland an Electrical Safety Form 4 is the compliance certificate issued by the licensed electrician on...

ACMA Open Cabler Registration is the broadest tier of the federal cabling-registration scheme and authorises the holder...

Below the ACMA Open registration sit four narrower endorsements — Restricted (single jack-points only, no MDF), Lift...

The Specialised Inspection Licence (SIL) in Victoria authorises an A-grade electrician with extensive post-trade...

The NSW Electrician Licence (commonly called the A-grade or unrestricted electrical licence) is issued by NSW Fair...

The Victorian A-grade Electrician's Licence is issued by Energy Safe Victoria (ESV) under the Electricity Safety Act...

The Queensland Electrical Work Licence (often referred to as the QLD A-grade equivalent) is issued by the Electrical...

The WA Electrical Worker's Licence (EW Licence) is issued by Building and Energy (formerly EnergySafety WA) under the...

In South Australia the Office of the Technical Regulator (OTR) registers Electrical Workers under the Electricity Act...

In Tasmania the Practitioner Licence — Electrician is issued by Consumer, Building and Occupational Services (CBOS)...

In the ACT the Electrical Licence is issued by Access Canberra under the Construction Occupations (Licensing) Act 2004...

In the Northern Territory the Electrical Licence is issued by the NT Electrical Workers and Contractors Licensing Board...

Cable jointers terminate, joint and pull underground low-voltage and high-voltage power cables for the distribution...

Instrumentation electricians work on process-control systems — refineries, gas plants, water treatment, breweries,...

In-service testing and tagging of electrical equipment plus residual-current device (RCD) testing is required under...

High-voltage switching authorisation allows a person to operate switchgear above 1000 V AC — substations, ring main...

Clean Energy Council (CEC) Installer Accreditation for grid-connect solar PV is the national scheme required for any...

CEC Designer accreditation (separate from Installer) authorises a person to design grid-connect solar PV systems —...

Battery Storage endorsement is added on top of the CEC Solar PV Installer or Designer accreditation and authorises the...

The Grid-Connect Inverter endorsement under the CEC scheme authorises connection of solar PV / battery / hybrid...

CEC accreditation has separate endorsements for Stand-Alone Power Systems (SAPS / off-grid), small wind turbines and...

A Disconnect / Reconnect Licence (DRL) is a restricted electrical licence held by non-electrician trades — most...

The Restricted Electrical Licence — Air-Conditioning class (commonly called ACEL) is issued by ESV in Victoria and...

A refrigeration-stream restricted electrical licence allows a Cert III refrigeration mechanic to perform electrical...

A specialised restricted electrical licence endorsement for technicians installing, maintaining and commissioning...

A specialty restricted electrical licence held by mechanical / mining / marine fitters and equipment maintenance...